Dell Technologies 14th Generation PowerEdge Server Troubleshooting Guide

PDF

How do I configure RAID using operating system deployment wizard

You can configure RAID using an operating System deployment wizard on the Dell Lifecycle controller. To configure RAID:

  • Launch the Lifecycle Controller.
  • In the left pane, click OS Deployment.
  • On the OS Deployment page, click Deploy OS.
  • On the Deploy OS page, click Configure RAID First, and then click Next.
  • The storage controllers available for configuration are displayed in the RAID Configuration page.
    NOTE:Make sure that the selected controller is not in a non-RAID mode.
  • Select a storage controller. The RAID configuration options are displayed.
  • Follow the instruction on the screen, complete the RAID setting tasks, and then click Finish.

The RAID configuration is applied to the virtual disks.

To create virtual disks using RAID configuration at the preferred RAID level, see How to create virtual disk.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\