Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Installing a drive into drive carrier

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Insert the drive into the drive carrier, with the connector end of the drive towards the back of the carrier.
  2. Align the screw holes on the drive with the screw holes on the drive carrier.
  3. Using the Phillips #1 screwdriver, replace the screws to secure the drive to the drive carrier.
    Figure 1. Installing a drive into the drive carrierThis image shows installing the drive into the drive carrier.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\