Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Installing an internal microSD card

Prerequisites

Follow the safety guidelines listed in Safety instructions.
  • NOTE: To use an microSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.

Steps

  1. Locate the microSD card connector on the internal dual SD module. Orient the microSD card appropriately and insert the contact-pin end of the card into the slot.
    • NOTE: The slot is keyed to ensure correct insertion of the card.
  2. Press the card into the card slot to lock it into place.
    • NOTE: Temporarily label each SD card with its corresponding slot before removal.

Next steps

Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\