Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Installing the drive cage

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Align the screw holes on the drive cage with the screw holes on the system.
  2. Lower the drive cage into the system until the drive cage is seated in place.
  3. Using the Phillips #1 screwdriver, replace the screws to secure the drive cage to the system.
    Figure 1. Installing the drive cageThis image shows installing the hard drive cage.

Next steps

  1. Install the drive backplane.

  2. Install the drives.

  3. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\