Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Installing the Network Daughter Card

Prerequisites

  • CAUTION: To prevent damage to the Network Daughter Card (NDC), you must hold the card only by its edges.
  1. Follow the safety guidelines listed in Safety instructions.

Steps

  1. Align the following:
    1. The slots on the card edge with the projection tabs on the plastic bracket covering the mezzanine card slots.
    2. Screw holes on the card with the standoffs on the system board.
  2. Lower the card into place until the card connector fits into the corresponding connector on the system board.
  3. Using the Phillips #2 screwdriver, replace the screws to secure the card.
    Figure 1. Installing the Network Daughter CardThis image shows installing the network daughter card.

Next steps

  1. Install the mezzanine card.

  2. Follow the procedure listed in After working inside your system .


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\