Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Installing the rSPI card

Prerequisites

Follow the safety guidelines listed in Safety instructions.
  • CAUTION: To prevent damage to the rSPI card, you must hold the card only by its edges.

Steps

  1. Align the screw hole on the rSPI card with the standoff on the system board.
  2. Using the Torx #8 screwdriver, replace the screw to secure the rSPI card to the system board.
    Figure 1. Installing the rSPI cardThis image shows installing the rSPI card.

Next steps

  1. Install the system board.
  2. Follow the procedure listed in After working inside your system .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\