Dell EMC PowerEdge M640 Installation and Service Manual
Options to set up iDRAC IP address
You must configure
the initial network settings based on your network infrastructure
to enable the communication to and from iDRAC.
This option is set to DHCP by Default. You can set up the IP address by using one of the following interfaces:
- Interfaces
- Document/Section
- iDRAC Settings utility
- See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/poweredgemanuals
- Dell Deployment Toolkit
- See Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanuals > OpenManage Deployment Toolkit
- Dell Lifecycle Controller
- See Dell Lifecycle Controller User’s Guide at Dell.com/poweredgemanuals
- CMC Web interface
- See Dell Chassis Management Controller Firmware User’s Guide at Dell.com/idracmanuals > Dell.com/cmcmanuals
- iDRAC Direct
- See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/poweredgemanuals
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\