Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Removing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Remove the air shroud.
  4. Remove the BOSS card.
    • NOTE: Removing the BOSS card is similar to the procedure for removing an expansion card riser.

Steps

  1. Loosen the screws and lift the retention straps that secure the M.2 SSD module on the BOSS card.
  2. Pull the M.2 SSD module away from the BOSS card.
    Figure 1. Removing the M.2 SSD module This image shows removing the M.2 SSD module
    1. module connector (2)
    2. screws (2)
    3. module (2)

Next steps

Install the M.2 SSD module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\