Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Removing the optional internal dual SD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Remove the air shroud.
  • NOTE: The procedure to remove IDSDM and the BOSS M.2 card is the same.

Steps

  1. Pressing the release latches, lift the drive backplane only until the guide pins on the drive cage disengage from the guides on the drive backplane.
  2. Using the Phillips #2 screwdriver, loosen the retention screw that connects the internal dual SD module (IDSDM) to the system board.
  3. Lift the release tab that secures the IDSDM to the system board.
  4. Holding both ends of the IDSDM, lift the IDSDM out of the IDSDM/BOSS M.2 connector on the system board.
    Figure 1. Removing the optional IDSDM moduleThis image shows removing the internal dual SD module.

Next steps

Install the IDSDM .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\