Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Removing the processor from the processor and heat sink module

Prerequisites

  • WARNING: The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink to cool before removing it.
  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system .
  3. Remove the air shroud .
  4. Remove the processor and heat sink module .

Steps

  1. Insert a flat blade screwdriver into the release slot marked with a yellow label. Rotate (do not pry) the screwdriver to break the thermal paste seal.
  2. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
    Figure 1. Loosening the processor bracket This image shows loosening the processor bracket
  3. Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor tray.
  4. Flex the outer edges of the bracket to release the processor from the bracket.
    • NOTE: Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
    Figure 2. Removing the processor bracket This image shows removing the processor bracket

Next steps

Install the processor into the processor and heat sink module .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\