Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Removing the rSPI card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system .

  3. Remove the system board.

Steps

  1. Using the Torx #8 screwdriver, remove the screw securing the rSPI card to the system board.
  2. Holding the rSPI card by its edges, lift the card away from the system.
    • CAUTION: To prevent damage to the rSPI card, you must not tilt the card while lifting it from the system board.
    Figure 1. Removing the rSPI cardThis image shows removing the rSPI card.

Next steps

Install the rSPI card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\