Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Removing the storage controller card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system .

  3. Remove the following:

    1. Drives

    2. Drive backplane

    3. Drive cage

Steps

  1. Using the Phillips #2 screwdriver, loosen the retention screws on the drive cable connector and lift it away from the storage controller card.
    • CAUTION: To prevent damage to the storage controller card, you must hold the card only by its edges.
  2. Lift the storage controller card away from the system.
    Figure 1. Removing the storage controller cardThis image shows removing the storage controller card.

Next steps

Install the storage controller card .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\