Dell EMC PowerEdge M640 Installation and Service Manual

PDF

Removing the system cover

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Turn off the system.
  3. Remove the system from the enclosure.
  4. Install the I/O connector cover.

Steps

  1. Press the release button, and slide the cover toward the back of the system.
  2. Lift the cover away from the system.
    Figure 1. Removing the system coverThis image shows removing the system cover

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\