Dell Lifecycle Controller GUI v2.70.70.70 User's Guide
Importing server profile after system board replacement
Before importing
the server profile after replacing the system board, make sure that
the following prerequisites are met:
- A backup image of the server with the old system board is present.
- If you are restoring from a vFlash SD card, it must be installed, and contain the backup image in a folder labeled SRVCNF. This image must be from the same server that you are trying to restore.
- If you are restoring from a network share, make sure that the network share where the backup image file is stored is accessible.
After replacing the system board, import the server profile from a vFlash SD card, network share, or a USB device.
- See Post-Import Scenario.
- The Service Tag is restored on the new system board from the backup file.
NOTE: Lifecycle
Controller prompts you with a dialog box to retrieve the Service Tag
and restore the server profile, if you have replaced a system board
and have not entered the Service Tag on the replaced system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\