Dell Lifecycle Controller GUI v2.70.70.70 User's Guide
Post reboot scenarios
The following table lists the post reboot scenarios, its user actions, and impact.
| Scenario | User Action and Impact |
|---|---|
| During POST, the system prompts you to press a key to boot to the operating system installation media. |
Press any key to begin the operating system installation; else, the system boots to the hard-disk drive and not the operating system installation media. |
| Operating system installation is interrupted and the system restarts before the installation is completed. |
The system prompts you to press a key to boot from the operating system installation media. |
| Cancel operating system installation. |
Press <F10>. NOTE: If you
press <F10> during the installation process or a restart,
the drivers provided by the operating system deployment wizard are
removed. |
| During the 18-hour period when drivers are extracted to a temporary location after the operating system is installed, you cannot update the component firmware using a DUP. If you attempt a DUP through the operating system during this time period, the DUP displays a message that another session is active. |
Lifecycle Controller does not allow DUP after the operating system installation. However, if you disconnect the power supply to the managed system, the OEMDRV directory is erased. |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\