XPS 8940 Service Manual

PDF

Installing the processor fan and heat-sink assembly (125 W)

Prerequisites

CAUTION: If either the processor or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure that thermal conductivity is achieved.

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE: The following procedure only applies to computers shipped with a 125 W processor.

The following images indicate the location of the processor fan and heat-sink assembly and provide a visual representation of the installation procedure.

Image: Installing the processor fan and heat-sink assembly

Steps

  1. Align the numbering on the processor fan and heat-sink assembly with the numbering on the system board.
  2. In the sequential order (1->2->3->4), tighten the captive screws that secure the processor fan and heat-sink assembly to the system board.
  3. Connect the processor-fan cable to the system board.

Next steps

  1. Install the left-side cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\