XPS 8940 Service Manual

PDF

Installing the voltage regulator heat sink

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the voltage regulator heat sink and provide a visual representation of the installation procedure.

Image: Installing the VR heat sink

Steps

  1. Align and place the voltage regulator heat sink on the system board.
  2. Tighten the captive screws that secure the voltage regulator heat sink to the system board.

Next steps

  1. Install the left-side cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\