Alienware 15 R3 Service Manual

Procedure

  1. Connect the battery cable to the system board.
  2. Slide the tabs on the base cover into the slots on the computer base and snap the base cover into place.
  3. Tighten the captive screw that secures the base cover to the computer base.
  4. Replace the six screws (M2.5x13) that secure the base cover to the computer base.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\