Alienware 15 R3 Service Manual

Procedure

  1. Disconnect the coin-cell battery cable from the system board.
  2. Peel off the tape that secures the coin-cell battery cable to the system board.
  3. Note the cable routing and remove the coin-cell battery cable from the routing guide on the palm-rest assembly.
  4. Gently peel off the coin-cell battery along with its cable off the palm-rest assembly. Image: Removing coin-cell battery

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\