Alienware 15 R3 Service Manual

Procedure

  1. Using the alignment posts on the palm rest, place the touch pad on the palm-rest assembly.
  2. Align the screw holes on the touch-pad bracket with the screw holes on the palm-rest assembly.
  3. Replace the five screws (M2x3) that secure the touch-pad bracket to the palm-rest assembly.
  4. Slide the touch-pad cable and touch-pad buttons cable into their respective connectors on the touch pad and close the latches to secure the cables.
  5. Slide the touch-pad cable into the connector on the system board and close the latch to secure the cable.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\