Alienware 15 R3 Service Manual

Procedure

  1. Slide the display cable into the connector on the display panel and close the latch to secure the cable.
  2. Adhere the tape that secures the display cable to the display panel.
  3. Turn the display panel over and gently place it on the display back-cover.
  4. Align the screw holes on the display panel with the screw holes on the display back-cover.
  5. Replace the four screws (M2x3) that secure the display panel to the display back-cover .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\