Alienware 15 R3 Service Manual

Procedure

  1. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
  2. Slide the solid-state drive into the solid-state drive slot.
  3. Slide and adhere the solid-state drive shield on the solid-state drive.
  4. Replace the screw (M2x3) that secures the solid-state drive and solid-state drive shield to the computer base. Image: Replacing the solid-state drive

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\