Alienware 15 R3 Service Manual

Procedure

  1. Slide the power-adapter port into the slot on the palm-rest assembly.
  2. Route the power-adapter port cable through the routing guides on the palm-rest assembly.
  3. Align the screw hole on the power-adapter port bracket with the screw hole on the palm-rest assembly.
  4. Replace the screw (M2x3) that secures the power-adapter port bracket to the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\