Alienware 15 R3 Service Manual

Procedure

  1. Remove the six screws (M2.5x13) that secure the base cover to the computer base.
  2. Loosen the captive screw that secures the base cover to the computer base. Image: Removing the base cover
  3. Using a plastic scribe, gently pry to release the tabs on the base cover from the slots on the computer base.
  4. Lift the base cover off the computer base.Image: Removing the base cover
  5. Disconnect the battery cable from the system board. Image: Disconnecting the battery cable
  6. Press and hold the power button for five seconds to ground the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\