Alienware 15 R3 Service Manual

Procedure

  1. Peel the tape that secures the I/O-board cable to the I/O board.
  2. Open the latch and disconnect the I/O-board cable from the I/O board.
  3. Remove the two screws (M2.5x5) that secure the I/O board to the palm-rest assembly.
  4. Lift the I/O board off the palm-rest assembly.Image: Removing the I/O board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\