Alienware 15 R3 Service Manual

Procedure

  1. Open the latch and disconnect the touch-pad cable from the system board.
  2. Open the latches and disconnect the touch-pad cable and the touch-pad buttons cable from the touch pad.
  3. Remove the five screws (M2x3) that secure the touch-pad bracket to the palm-rest assembly.
  4. Lift the touch-pad bracket off the palm-rest assembly. Image: Removing the touch-pad bracket
  5. Lift the touch pad off the palm-rest assembly.Image: Removing the touch pad

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\