Alienware 15 R3 Service Manual

Procedure

  1. Note the cable routing and remove the antenna cables from the routing guides on the computer base.
  2. Disconnect the tron-light cable from the system board.
  3. Open the latch and disconnect the macro-keys cable, and then remove the cable from the routing guide on the computer base.
  4. Open the latch and disconnect the keyboard-backlight cable, and then remove the cable from the routing guide on the computer base.
  5. Open the latch and disconnect the keyboard cable, and then remove the cable from the routing guide on the computer base.
  6. Disconnect the tron-light cable from the system board. Image: Removing computer base
  7. Remove the two screws (M2x3) that secure the computer base to the palm-rest assembly.
  8. Remove the 11 screws (M2.5x8) that secure the computer base to the palm-rest assembly. Image: Removing computer base
  9. Lift the computer base off the palm-rest assembly.Image: Removing computer base

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\