Alienware 15 R3 Service Manual

Procedure

  1. Remove the screw (M2x3) that secures the solid-state drive shield and solid-state drive to the computer base.
  2. Peel off the solid-state drive shield from the solid-state drive.
    • NOTE: Solid-state drive shield is applicable to computers that are shipped with 1 TB solid-state drive.
  3. Slide and remove the solid-state drive from the solid-state drive slot. Image: Removing the solid-state drive

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\