Alienware 15 R3 Service Manual

Procedure

  1. Align the screw holes on the heat-sink assembly with the screw holes on the system board.
  2. Replace the seven screws (M2x3) that secure the heat-sink assembly to the system board.
  3. Turn the system-board assembly over.
    • NOTE: For computers shipped with NVIDIA GeForce GTX 1060 graphics controller, place the fans on the slots on the system board.
  4. Adhere the tape to secure the fan cables to the system-board assembly.
  5. Connect the fan cables to their respective connectors on the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\