Alienware 15 R3 Service Manual

Procedure

  • CAUTION: To avoid damaging the wireless card, do not place any cables under it.
  1. Align the notch on the wireless card with the tab on the wireless-card slot.
  2. Slide the wireless card at an angle into the wireless-card slot.
  3. Connect the antenna cables to the wireless card. The following table provides the antenna-cable color scheme for the wireless card supported by your computer.
    Table 1. Antenna-cable color scheme
    Connectors on the wireless card Antenna cable color
    Auxiliary (black triangle) Black
    Main (white triangle)White
  4. Align the screw hole on the wireless-card bracket with the screw hole on the wireless card and the computer base.
  5. Press the other end of the wireless card and replace the screw (M2x3) that secures the wireless-card bracket to the computer base. Image: Replacing the wireless card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\