Alienware Area-51 AAT2250 Owner's Manual

PDF

Screw list

NOTE:When removing screws from a component, it is recommended to note the screw type and the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced.
NOTE:Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when replacing a component.
NOTE:Screw color may vary depending on the configuration ordered.
Table 1. Screw listThe following table provides the different screws that are used in your Alienware Area-51 AAT2250.
Component Screw type Quantity Screw image
Left cover #6-32 1 Image: #6-32
Right cover #6-32 1 Image: #6-32
Top cover M3x5 2 Image: M3x5
Single-graphics card #6-32 2 Image: #6-32
M.2 2230 or M.2 2280 SSD (installed in slots M.2 PCIe SSD-0, M.2 PCIe SSD-1, or M.2 PCIe SSD-2) M2x3.5 1 Image: M2x3.5
Wireless card M2x3.5 1 Image: M2x3.5
Power-supply unit cover M2x5 2 Image: M2x5
Power-supply unit holder #6-32 2 Image: #6-32
Power supply unit (850 W or 1500 W) #6-32 4 Image: #6-32
AlienFX board #6-32 3 Image: #6-32
2.5-inch hard drive cage #6-32 1 Image: #6-32
2.5-inch hard drive M3x5 4 Image: M3x5
Top I/O-panel #6-32 1 Image: #6-32
Front bezel #6-32 2 Image: #6-32
Side light M3x3 2 Image: M3x3
Top-fan assembly M3x5 4 Image: M3x5
Top fan #6-32 4 Image: #6-32
Front fan M3x5 2 Image: M3x5
Bottom fan M3x5 2 Image: M3x5
SMA cable M3x3 2 Image: M3x3
System board #6-32 9 Image: #6-32

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\