Alienware Command Center 6.x User's Guide

PDF

Configure sleep and wake mode

From AWCC 6.2, you can configure the time before the computer enter sleep mode. You can also configure the pro device actions through which the computer is woken up.

Steps

  1. Select the device under ALIENFX.
  2. Go to Setting > Battery.
  3. Configure the time before the computer enter sleep mode using the SLEEP (MINUTES) slider.
  4. Select any of the following actions through which the computer is woken up:
    • Allow this device to wake the computer
    • Mouse Movement
    • Button Presses/Scroll wheel activity
  5. Click Save Preset.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\