Alienware m15 R3 Service Manual

PDF

Flea power release

About this task

Flea power is the residual static electricity that remains on the computer even after it has been powered off and the battery has been removed. The following procedure provides the instructions on how to conduct flea power release:

Steps

  1. Turn off your computer.
  2. Disconnect the power adapter from your computer.
  3. Remove the base cover.
  4. Disconnect the battery cable from the system board.
  5. Press and hold the power button for 15 seconds to drain the flea power.
  6. Connect the battery cable to the system board.
  7. Install the base cover.
  8. Connect the power adapter to your computer.
  9. Turn on your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\