Alienware m15 R3 Service Manual
Installing the base cover
Prerequisites
About this task
The following image(s) indicate the location of the base cover and provides a visual representation of the installation procedure.
Steps
- Connect the battery cable to the system board.
- Adhere the tape that secures the battery cable to the battery.
- Slide the notches on the top of the base cover under the rear I/O-cover and snap the base cover into place on the palm-rest assembly.
- Tighten the six captive screws on the base cover.
- Replace the two screws (M2x5) that secure the base cover to the palm-rest assembly.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\