Alienware m15 R3 Service Manual

PDF

Installing the palmrest

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the palmrest and provides a visual representation of the installation procedure.

Installing the palmrest

Steps

To install the palmrest perform the post-requisites.

Next steps

  1. Install the keyboard.
  2. Install the power-button assembly.
  3. Install the power-adapter port.
  4. Follow the procedure from step 3 to step 24 in Installing the system board.
  5. Install the right I/O-board.
  6. Install the keyboard-controller board.
  7. Install the touchpad.
  8. Install the speakers.
  9. Install the display assembly.
  10. Install the rear I/O-cover.
  11. Install the M.2 2230 solid-state drive. (if applicable)
  12. Install the M.2 2280 solid-state drive. (if applicable)
  13. Install the battery.
  14. Install the base cover.
  15. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\