Alienware m15 R3 Service Manual

PDF

Installing the power-button assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the power-button assembly and provides a visual representation of the installation procedure.

Installing the power-button assembly

Steps

  1. Place the power-button assembly and its cable in the slot on the palm-rest assembly.
  2. Place the power-button bracket on the power-button assembly.
  3. Align the screw holes on the power-button bracket to the screw holes on the palm-rest assembly.
  4. Replace the three (M2x1.9) screws that secure the power-button bracket to the palm-rest assembly.
  5. Adhere the power-button assembly cable on the palm-rest assembly.

Next steps

  1. Follow the procedure from step 3 to step 24 in Installing the system board.
  2. Install the right IO-board.
  3. Install the rear IO-cover.
  4. Install the M.2 2230 solid-state drive. (if applicable)
  5. Install the M.2 2280 solid-state drive. (if applicable)
  6. Install the battery.
  7. Install the base cover.
  8. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\