Alienware m15 R3 Service Manual

PDF

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the speakers and provides a visual representation of the installation procedure.

Installing the speakers

Steps

  1. Using the alignment posts, place the left speaker on the palm-rest assembly.
    NOTE Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
  2. Route the speaker cable through the routing guides on the palm-rest assembly.
  3. Using the alignment posts, place the right speaker on the palm-rest assembly.
    NOTE Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
  4. Connect the speaker cable to the right I/O-board.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\