Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell APEX Cloud Platform MC-760 Hardware Requirements and Specifications

Create a system and setup password


Ensure that the password jumper is enabled. The password jumper enables or disables the system password and setup password features.

If the password jumper setting is disabled, the existing system and setup passwords are deleted. You are not required to provide the system password to boot the system.


  1. To enter System Setup, press F2 immediately after turning on or rebooting your system.
  2. On the System Setup Main Menu screen, click System BIOS and then System Security.
  3. On the System Security screen, verify that Password Status is set to Unlocked.
  4. In the System Password field, type your system password, and press Enter or Tab.
    A password can have up to 32 characters.
  5. Reenter the system password, and click OK.
  6. In the Setup Password field, type your setup password and then press Enter or Tab.
  7. Reenter the setup password, and click OK.
  8. Press Esc to return to the System BIOS screen. Press Esc again.
    A message prompts you to save the changes.

    Password protection does not take effect until the system reboots.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\