Dell EMC Boot Optimized Server Storage-S1 User's Guide

Controller replacement

Controller's UEFI configuration utility menu entry not appearing.
Probable Cause:
This is either a firmware or a hardware fault.
Corrective Action:
  • Flash the latest firmware on the BOSS adapter.
  • If the problem persists, shutdown the server and unplug the BOSS-S1 adapter.
  • Plug the BOSS-S1 adapter into the PCIe slot.
  • Boot the system and check the UEFI configuration utility menu again.

If the issue persists, see Controller Failure.

NOTE: Ensure that the system is completely disconnected from all power sources before making any hardware changes.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\