Dell EMC Boot Optimized Server Storage-S1 User's Guide

Installing the BOSS-S1 card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
    NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
  2. Open the system.
  3. Hold the card by its edges and align the card connector with the connector on the system board.
    CAUTION: To prevent damage to the card, hold the card by its edges only.
  4. Press the card-edge down until the card is fully seated.
  5. If you are installing a modular card, tighten the screw that secures the card to the system board.
  6. Close the system.
  7. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
    Figure 1. Installing the BOSS-S1 adapter card
    Installing the BOSS-S1 adapter card
    1. BOSS-S1 card
    2. card connector on the system board
    Figure 2. Installing the BOSS-S1 modular card
    Installing the Modular card
    1. modular card
    2. card connector on the system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\