Dell EMC Boot Optimized Server Storage-S1 User's Guide

Installing the M.2 SSD module on BOSS-S1 card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Align the M.2 SSD module connectors with the connectors on the card.
  2. Tilt the M.2 SSD module downwards until the module is seated firmly on the card.
  3. CAUTION: To avoid damage to the card, ensure that you do not over tighten the screw.
    Tighten the screw to secure the M.2 SSD module to the card.
    Figure 1. Installing M.2 SSD module on the BOSS-S1 card
    Installing the M.2 SSD module on the BOSS-S1 card
    1. module connector (2)
    2. screw (2)
    3. M.2 SSD module (2)
    Figure 2. Installing the M.2 SSD module on the BOSS-S1 modular card
    Installing the M.2 SSD module for Modular card
    1. module connector
    2. M.2 SSD module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\