Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell EMC Boot Optimized Server Storage-S1 User's Guide

Removing the BOSS-S1 card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
    NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
  2. Open the system.
  3. Locate the BOSS-S1 card on the system board.
    CAUTION: To prevent damage to the card, hold the card by its edges only.
  4. If you are removing a BOSS-S1 modular card, loosen the screw that secures the card to the system board.
  5. After ensuring that the PCIe bracket is unobstructed, lift the card to remove it from the connector on the system board.
    Figure 1. Removing the BOSS-S1 adapter card
    This image shows the removal of BOSS-S1 adapter card
    1. BOSS-S1 adapter card
    2. card connector on the system board
    Figure 2. Removing the BOSS-S1 modular card
    This image shows the removal of the BOSS-S1 modular card
    1. BOSS-S1 modular card
    2. card connector on the system board

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\