Dell EMC Boot Optimized Server Storage-S1 User's Guide

Removing the M.2 SSD module from the BOSS-S1 card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
    NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
  2. Open the system.
  3. Remove the BOSS-S1 card from the system. See Removing the BOSS-S1 card.
  4. Remove the screw that secures the M.2 SSD module to the BOSS-S1 card.
  5. Slide and remove the M.2 SSD module away from the card.
    Figure 1. Removing the M.2 SSD module from the BOSS-S1 adapter card
    Image shows the removal of the M.2 SSD module from the BOSS-S1 adapter card
    1. module connector (2)
    2. screw (2)
    3. M.2 SSD module (2)
    Figure 2. Removing the M.2 SSD module from the BOSS-S1 modular card
    Image shows the removal of the M.2 SSD module from the BOSS-S1 modular card
    1. module connector
    2. M.2 SSD module

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\