Dell Command | Configure Version 4.12.0 User's Guide

PDF

Applying a SCE file

NOTE:You must have Administrator privileges.

To apply SCE on a target computer, double-click the SCE, or from the command prompt, go to the directory where SCE is located and type the name of the SCE file. For example, C:\Users\SystemName\Documents>"<filename>”

Important Notes

  • You cannot run SCE on Windows PE computers. For more information about applying SCE on target computers running the Windows PE operating systems, see Troubleshooting.
  • The generated SCE file does not work on non-WMI-ACPI computer.
  • You must have admin privileges to access the directory where SCE is exported.
  • If you have configured an Encryption Passphrase while exporting the SCE, then the SCE can only be applied through the command prompt. For more information, see SCE details section.
  • For computers running Windows 11 with Smart App Control enabled, there may be issues with applying the SCE file. To avoid the issues, digitally sign the generated SCE files before applying them.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\