Dell DD and PowerProtect Hardware 8.0 Features and Specifications

PDF

DD9410 DIMM configurations

The system contains two Intel processors each with an integrated memory controller that supports eight channels of DDR5 memory. The CPU allows two DIMM slots per channel, so the SP Module supports 24 DIMM slots.

Each DDR5 DIMM is connected to the system board through an industry standard 288-pin DDR5 DIMM connector. This system uses registered DIMMs with Dell EMC ControlCenter at 72 bits wide (64-bits data + 8-bits Dell EMC ControlCenter) up to a maximum of 4800 MT/s speed.

Table 1. Memory configurationsMemory configurations
Total Memory Memory DIMM Configuration
768 GB 12 x 64 GB

Memory locations

To ensure maximum memory performance, there are memory DIMM population rules so that the memory loading and interleaving are optimal. The following table specifies the DIMM location rules. Each DIMM location contains a 64 GB DIMM.

Table 2. DD9410 DIMM configuration CPU 1DD9410 DIMM configuration CPU 1
Total (GB) Channel A Channel B Channel C Channel D Channel E Channel F Channel G Channel H
A1 A9 A7 A15 A3 A11 A5 A13 A4 A12 A6 A14 A2 A10 A8 A16
384 GB 64 GB N/A N/A N/A 64 GB N/A 64 GB N/A 64 GB N/A G4 GB N/A 64 GB N/A N/A N/A
Table 3. DD9410 DIMM configuration CPU 2DD9410 DIMM configuration CPU 2
Total (GB) Channel A Channel B Channel C Channel D Channel E Channel F Channel G Channel H
B1 B9 B7 B15 B3 B11 B5 B13 B4 B12 B6 B14 B2 B10 B8 B16
384 GB 64 GB N/A N/A N/A 64 GB N/A 64 GB N/A 64 GB N/A G4 GB N/A 64 GB N/A N/A N/A

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\