Dell DD and PowerProtect Hardware 8.0 Features and Specifications

PDF

Shock and vibration

Products have been tested to withstand the shock and random vibration levels. The levels apply to all three axes and should be measured with an accelerometer on the equipment enclosure within the cabinet and shall not exceed:

Table 1. Platform condition - shock and vibrationPlatform condition - shock and vibration
Platform condition Response measurement level
Non operational shock 10 G’s, 7 ms duration
Operational shock 3 G’s, 11 ms duration
Non operational random vibration 0.40 Grms, 4–500 Hz, 30 minutes
Operational random vibration 0.21 Grms, 5–500 Hz, 10 minutes

Systems that are mounted on an approved package have completed transportation testing to withstand the following shock and vibrations in the vertical direction only and shall not exceed:

Table 2. Packaged system condition - shock and vibrationPackaged system condition - shock and vibration
Packaged system condition Response measurement level
Transportation shock 10 G’s, 12ms duration
Transportation random vibration
  • 0.28 Grms
  • 4 hour Frequency range 1–100 Hz

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\