Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Adding warranty information

Use the omconfig system warranty or omconfig servermodule warranty command to assign values for warranty information. A warranty is a contract between the manufacturer or dealer and the purchaser of a system. The warranty identifies the components that are covered for repair or replacement for a specified length of time or usage. For details on editing extended warranty values, see Adding Extended Warranty Information . The following table displays the valid parameters for adding warranty information.

Table 1. Valid Parameters Of omconfig system assetinfo info=warranty Or omconfig servermodule assetinfo info=warranty . The following table describes the valid parameters for adding warranty information in the order of command level 1, level 2, level 3, name and value pair 1, name and value pair 2, and then the description.
Command Level 1 Command Level 2 Command Level 3 Name= Value Pair 1 Name= Value Pair 2 Description
omconfig system or servermodule assetinfo info=warranty cost=< cost> Cost of the warranty service.
        duration=< duration> Number of days or months that the warranty is in force.
        enddate=< enddate> Date the warranty agreement ends.
        unit=days | months Whether the number for duration refers to days or months.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\