Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Example command for adding acquisition information

To provide a value for an acquisition parameter, type a command of the form: omconfig system assetinfo info=acquisition <name=value pair 2> or omconfig servermodule assetinfo info=acquisition <name=value pair 2> . For example, type:
omconfig system assetinfo info=acquisition purchasedate=122101
or
omconfig servermodule assetinfo info=acquisition purchasedate=122101
The following message is displayed:
Asset information set successfully.
You can type more than one omconfig system assetinfo or omconfig servermodule assetinfo command at the same time, as long as all of the parameters for name=value pair 2 belong to the same name=value pair 1. For example, to type more than one parameter value for info=acquisition, use the following example as a syntax guide:
omconfig system assetinfo info=acquisition purchasecost=5000 
                                    waybill=123456 installdate=120501 purchasedate=050601 ponum=9999 signauth="John Smith" expensed=yes costcenter=finance
                                 
or
omconfig servermodule assetinfo info=acquisition purchasecost=5000 waybill=123456 installdate=120501 purchasedate=050601 ponum=9999
                                    signauth="John Smith" expensed=yes costcenter=finance
                                 
The following message is displayed:
Asset information set successfully.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\