Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

Example command for adding maintenance information

To provide a value for a maintenance parameter, type a command of the form: omconfig system assetinfo info=maintenance <name=value pair 2> or omconfig system assetinfo info=maintenance <name=value pair 2> .

For example, type:
omconfig system assetinfo info=maintenance startdate=012504
or
omconfig servermodule assetinfo info=maintenance startdate=012504
The following message is displayed:
Asset information set successfully.

You can type more than one omconfig system assetinfo or omconfig servermodule assetinfo command at the same time, as long as all the parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see Example Commands For Adding Acquisition Information .


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\