Dell EMC OpenManage Command Line Interface Guide Version 9.1

PDF

List

The default format is lst or list format. Use this format when you want to optimize output for simple readability. You need to specify a format for the command output only if you want a format other than the lst format.

To see the following example command output in lst format, type:
omreport system summary
or
omreport servermodule summary
No special formatting option is required because list format is the default display format. The network data part of the example system summary is displayed as follows:
--------------
                                    Network Data
                                    --------------
                                    Network Interface 0 
                                    IP Address	: 143.166.152.108
                                    Subnet Mask	: 255.255.255.0
                                    Default Gateway	: 143.166.152.1
                                    MAC Address	: 00-02-b3-23-d2-ca
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\